Handmade Wooden Circular Rib - C3 Internal Shaper & Surface Refiner

10 cm diameter
Cherry Wood

Maintenance Recommendations

Wash by hand with water removing all clay or mud, dry with a towel and let air dry.
Do not leave your tools submerged in water or soaked.
When you use the tool on the lathe, you can submerge it in the basin water to clean it but then leave it outside, do not leave it floating.
Do not use chemicals or abrasives.
Do not leave your very wet tools to dry lying on the table or on the plasterboard; it is important to dry them after washing them with the cloth and leave them hanging from the hole or standing upright on their base, but always let air circulate around them so that the wood can expel any remaining water naturally.
Apply mineral oil and beeswax ointment or some other special wood oil occasionally.
For occasional maintenance you can use very fine 240 sandpaper and special natural ointments or oils for wood, allowing the product to dry 24 hours before use.
If at any time you notice that the wood is rougher than you like after the first use or at later times, you can gently sand the surface with fine 240 sandpaper and reapply protection for a smoother finish to the touch.  This aspect does not affect the correct operation of the tool.
The final product may have slight variations in color and wood grain due to the use of a natural raw material.

SAFETY WARNING

Handle with care: Some tools have pointed ends. While they are not sharpened, they can cause skin injury if used or handled improperly.

Professional use: Keep out of reach of children. Use only for pottery purposes.